05-08 MASTERCRAFT X-7 W/TOWER SUN-D

Carver® Boat Covers, made in South Carolina, USA for 40+ years. This cover was patterned from this EXACT Year, Make & Model boat setup, so it is GUARANTEED TO FIT perfectly. Offered in three Solution-Dyed (dye goes completely through the threads, to reduce fading) Marine Grade fabrics. DOUBLE-STITCHED using weather resistant anti-wick thread and FOLDED FOUR-PLY JOIN SEAMS (no raw edges) with DURABLE REINFORCEMENTS sewn (not glued) in at major wear points for extra for added strength and durability. TRAILERABLE at reasonable speeds when cinched tightly and tied down with 12 FREE Heavy Duty TIE-DOWN STRAPS (6 on smaller covers) connected to Sturdy TIE-DOWN LOOPS double sewn in the hem in an offset \"V\" for strength and less strap twisting. 1 or 2 PADS with SNAPS sewn inside cover for optional Support Poles. MOTOR COVER included on most outboard models. Ships in a sturdy box weighing approximately (1.1 X the length of the boat) in pounds. Heavy duty 1/4-inch CINCH ROPE (Not Elastic Cord) sewn into the hem cinches tightly around the boat below the rub rail. Fits Standard Integrated Fiberglass Swim Platform. Does NOT FIT THE FOLLOWING UNLESS SPECIFICALLY STATED IN BOAT DESCRIPTION: Other boat models or years, Wakeboard Tower, Folded or Upright Bimini-Top, Radar Arch, Camper-Top, T-Top, Hard-Top, Ski Tow Pylon, Non-Integrated Swim Platform, Bow or Stern Mounted Trolling Motor, Raised or protruding antennas, brackets, winches, mirrors, rod holders, etc. Will NOT fit ANY NON-Factory-Installed Arch, Top or Tower. NOT intended for LIFT use. May not be suitable for in-water mooring use. Does NOT Snap On.