94-00 VIP VALIANT 1996 I/O SUNBREL

Carver® Boat Covers, made in South Carolina, USA for 40+ years. This cover was patterned from this EXACT Year, Make & Model boat setup, so it is GUARANTEED TO FIT perfectly or we will correct it. Be sure this is your exact boat, because this cover is subject to a 35% restocking fee. Offered in three Solution-Dyed (dye goes completely through the threads, to reduce fading) Marine Grade fabrics. DOUBLE-STITCHED using weather resistant anti-wick thread and FOLDED FOUR-PLY JOIN SEAMS (no raw edges) with DURABLE REINFORCEMENTS sewn (not glued) in at major wear points for extra for added strength and durability. TRAILERABLE at reasonable speeds when cinched tightly and tied down with 12 FREE Heavy Duty TIE-DOWN STRAPS (6 on smaller covers) connected to Sturdy TIE-DOWN LOOPS double sewn in the hem in an offset "V" for strength and less strap twisting. 1 or 2 PADS with SNAPS sewn inside cover for optional Support Poles. MOTOR COVER included on most outboard models. Ships in a sturdy 19x12x12 (up to 14 foot), 22x14x13 (14.5-19 foot), 25x16x16 (19.5-21 foot) or 27x18x18 (over 21 foot) box weighing approximately ( 1.1 X the length of the boat ) in pounds. NO RISK! GUARANTEED TO FIT the 1994-2000 VIP® VALIANT 1996, I/O. Use on a trailer, dry stack or float dock. Does NOT use Snaps. Heavy duty 1/4-inch CINCH ROPE (Not Elastic Cord) sewn into the hem cinches tightly (can use Rope Ratchet below) around the boat below the rub rail. Fits Standard Integrated Fiberglass Swim Platform. Does NOT FIT THE FOLLOWING UNLESS SPECIFICALLY STATED IN BOAT DESCRIPTION: Other boat models or years, Wakeboard Tower, Folded or Upright Bimini-Top, Radar Arch, Camper-Top, T-Top, Hard-Top, Ski Tow Pylon, Non-Integrated Swim Platform, Bow or Stern Mounted Trolling Motor, Raised or protruding antennas, brackets, winches, mirrors, rod holders, etc. Will NOT fit ANY NON-Factory-Installed Arch, Top or Tower. NOT intended for LIFT use. May not be suitable for in-water mooring use. Does NOT Snap On.