AQUA JET FLOW MASTER 5.0 GPM 24V 3.5 BAR

The Johnson 10-13329-104 is a Polypropylene Aqua Jet Flow Master WPS 5.0 24V Water Pressure Pump, variable flow diaphragm pump and motor pressure system, with EPDM Diaphragm, coupled to a 24 Volts DC Motor. This pump can operate in fresh or sea water. This self-priming Aqua Jet Flow Master WPS 5.0 pump incorporates state-of-the-art electronics to automatically control the pump speed. The digital controller adjusts water flow as the demand is increased and decreased while maintaining a very smooth flow. The unique variable flow feature of the Aqua Jet Flow Master WPS 5.0 pump makes it a smart choice for better flow, lower noise and less amp draw. When water is demanded at the faucet or shower the pressure decreases. After a slight drop in pressure below 50 psi the integrated digital controller automatically soft starts the pump to maintain the required pressure. As more water is demanded this controller detects a drop in pressure and automatically increases the motor speed which increases the flow volume. As demand is reduced the digital control will reduce the motor speed until the pressure reaches 50 psi at which point the pump is automatically turned off. The durable construction and thoughtful design of the Flow Master 5.0 will provide many years of service. The Flow Master 5.0 offers variable speed, a quiet operation, smooth flowing, and self priming. The digital controller turns the pump on and off automatically when tap is opened and closed. It provides dry running without damage, low power consumption, and quick disconnect fittings. The Flow Master 5.0 is a self-priming pump, self-priming up to 2.5 m/8.2 feet. and the intake lines must be air tight to ensure self priming. A dry running Pump will not be damaged by only a short periods of dry running. Take caution and do not use this pump for any other liquids than fresh-water and sea-water. The maximum temperature of liquid +50 degrees C/+120 degrees F and maximum ambient temperature of +60 degrees C/+140 degrees F. A PUMProtector Inlet Strainer included. It is recommended to install with an accumulator tank.