Ford FE Single Supercharger Kit

The TorqStorm Ford FE Single Supercharger Kit provides a comprehensive solution for adding forced induction to your 390, 427, or 428 Ford Big Block FE engine. Included in the kit are the TorqStorm supercharger, couplers, clamps, blow-off valve and tube, air filter, carb hat, and all essential brackets, pulleys, and hardware for a complete engine installation. However, additional components are required for vehicle integration, such as a blow-through carburetor or throttle body injection system, an electronic fuel pump with adequate pressure capabilities, a 1:1 boost-referenced fuel pressure regulator, and an ignition system capable of pulling timing under boost (e.g., MSD BTM 6462). Premium fuel is mandatory when operating with boost. Intercooling is recommended for non-carbureted applications, and a bung for water-methanol injection is provided. If retaining a carbureted setup, a blow-through carburetor is necessary. This product is not for use with motor vehicle pollution control devices and is not legal for sale, installation, or use on licensed vehicles in California due to not meeting CARB compliance. It is strictly intended for racing vehicles that will never be used on a highway and is not applicable for street or highway use. Available in Natural Billet and Black finishes, lead times are typically 4 weeks for standard finishes and up to an additional 2 weeks for black anodized kits. TorqStorm recommends careful consideration of all component quality, even in premium kits. This part is legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles and Racing Use Only Vehicles, defined as pre-1966/1967 U.S. vehicles or pre-1968 foreign vehicles, and exclusively competition vehicles respectively. Installation on Emissions Controlled Vehicles (1966/1968 and newer) is against the law.