Pro-Kit Lowering Springs, -25mm Front / -20mm Rear

This kit provides a front lowering of 25mm and a rear lowering of 20mm, reducing the vehicle's center of gravity. With a front axle load capacity of up to 1030kg and a rear axle load capacity of up to 1055kg, these springs aim to reduce body roll during cornering and decrease squat under acceleration. The exact lowering measurement may vary depending on the vehicle's engine, transmission, equipment, and factory-installed suspension. Installation is recommended to be performed by a qualified workshop with the necessary special tools. After installation, wheel alignment is required. Eibach also strongly recommends replacing stock shock absorbers if they are worn, or upgrading to sport shocks, as this can become necessary after approximately 40,000 kilometers of OE damper mileage. The use of sport shock absorbers, such as the Bilstein B8, is suggested for optimal performance. It is important to note that the usage of these springs may be excluded in cases of vehicle reconstruction, including the installation of accessory brake systems (like ceramic brakes), sport suspension, or LPG systems. If the vehicle is equipped with serial electronic damper control, this feature will no longer be available when using the Pro-Kit, and a trouble code may appear. This can be reprogrammed by an official garage, or Eibach's Pro-Tronic system can be used to avoid the trouble code if available for the vehicle.